STUDY AND DETERMINATION OF RATIONAL OPERATING RATIO FOR PERCUSSION DRILLING MACHINES
DOI:
https://doi.org/10.4314/jfas.v12i2.16Keywords:
Axial force; Rotation and Penetration speed; Properties of the rock.Abstract
In this paper, we have the percussive rotational drilling regime that is determined by the combination of the rotational speed of the tool, the axial force applied on the rock; the optimal values of these parameters depend in particular on the type of tool and on the physico-mechanical properties of the rocks to be felled. The aim of the research is to improve the operating regimes of percussive drilling machines under the conditions of the Algerian limestone quarries (Hadjar-soud quarry) and to obtain a better compromise between the technical and economic indices, in order to ensure a minimum cost price for a meter of drilled hole. The experimental results carried that this methodology, which consists of assuming that under the concrete conditions can find the combination of the setting parameters that ensure the best techno-economic indices, as well as to carpenter the cost price for a meter of drilled holes.
Downloads
References
[2] Ouadio M, Assenvo.I. Machines of drilling. OPU, 1st part, Algiers.,1990, 5-12.
[3] Mckenziem J.C, Dodds G.-S, Mersey kingsway tunnel construction. Proc. Instn. Civ. Engnrs, March 1972, 1(5)1,503-533.
[4] Khochemane L. Optimisation of the parameters for the machines of drilling to serrated rollers under the conditions of the career of OUENZA. Thesis, 2006, 10-38.
[5] N.S.M., Brown J.G.W. Performance of full facers on kielder tunnels and tunnellings, 1977, 4(9), 35-39.
[6] Kahraman S, Bilgin N, Feridunoglu C. Dominantrock properties affecting the penetration rate of percussive drills, Int. J. Rock Mech. Min. Sci.2003, 40, 711-723.
[7] Changheon S, Jintai C, Kim J-H, Oh J.-Y., Design optimization of a drifter using the taguchi method for efficient percussion drilling. Journal of Mechanical Science and Technology. 2017, 31(4), 1797–1803.
[8] Murray R, Spiegel, 1985. Probability and Statistics, Paris.
[9] Atkinson T, Cassapi V-B, Morris R. The management of synergistic wears in mineral exploitation."Anti-Wear 88", the Royal Society. London, Sept 1988, 91-97.
[10] Moraveji M-K, Naderi M. Drilling rate of penetration prediction and optimization using response surface methodology and at algorithm. J. Nat. Gas Sci. Eng, 2016, 31, 829–841.
[11] Marta F, Riihioja K, Chitombo G. Drilling composite carbon materials using a drill bit. Part I: Five-step, Drilling Representation and Factors Affecting Maximum Force and Torque, 2005, pp.70-75.
[12] Alimovo, Krapivin M. Mining tool. Edition NADRA, 1979, Moscow.
[13] Rabinder G, Kirpitchev V. Mining and drilling equipments, Edition NADRA, Moscow, 1983.
Submissions
